Electrical Engineering Design

The fortunes of the heavy electrical industry have been closely linked to the development of the power sector in India. The heavy electrical industry has under its purview power generation, transmission, distribution and utilisation equipments. These include turbo generators, boilers, turbines, transformers, switchgears and other allied items. These electrical equipments (transformers, switchgears, etc) are used by almost all the sectors. Some of the major areas where these are used include power generation projects, petrochemical, refineries , chemical plants, integrated steel plants, non-ferrous metal units, etc.

The design, engineering and construction of industrial plants involves a multi disciplinary team effort. The goal is to design safe and dependable processing facilities in a cost effective manner. The fact is that there are very few formal training programs that focus on design and engineering of Electrical systems of such big plants. Therefore, most of the required skills are acquired while on the job, reducing productivity and efficiency.

The objective of this course is to provide the delegates the basic knowledge and skills in this discipline to facilitate faster learning curves while on the job.

Topics to be Covered in Workshop

Day 1: Session 1

Introduction to Engineering, Procurement, and Construction (EPC) Sector
Design task and introduction to various phases of the project.
Basics of electrical engineering

Day 1: Session 2

Preparations of single line diagram
Preparation of control schematics
Equipment sizing, selection, protection, specification, data-sheet, vendor data review and testing Generators, Transformers, Motors, Switchgears, Power capacitor banks Power reactor, Bus duct, DC-ups, AC-ups, Instrument transformers etc.

Day 2: Session 1

System studies
Load flow study
Short circuit analysis
Motor acceleration analysis
Transformer sizing
Hazardous area classification
SCADA / ENMCS/ PMS
Lighting design Earthing /grounding design Cabling system
Substation/switchyard design

Day 2: Session 2

Fire alarm system
CCTV system
PA/GA system
Telephone and LAN system
Radio system
2D/ 3D Modeling
Design Management
Project Management

Hardware Kit: This workshop does not include any hardware kit.

Requirements:
- A working Laptop/PC with minimum of 2 GB RAM, 100 GB HDD, intel i3+ processor
- A Seminar Hall with sitting capacity of all participants along with charging plugs, proper ventilation
- Projector, Collar Mike and Speakers

Benefits:
- Digital toolkit of PPTs and study material for all participants
- Certificate of Participation for every participant.
- A competition will be organized at the end of the workshop and winners will be awarded by Certificate of Excellence.